MIL-DTL-24402F(SH)
6. NOTES
(This section contains information of a general or explanatory nature that may be helpful, but is not mandatory.)
6.1 Intended use. The filter assemblies, filter elements, and differential pressure indicators covered by this
specification are intended for use in submarine and surface ship petroleum base, water glycol, and triaryl phosphate
ester fluid hydraulic systems. For application to systems using other than these fluids, users are cautioned to ensure
compatibility with filter assemblies and elements herein. When fluids of lower viscosities are used, the filter
assemblies may be suitable for higher flow rates.
6.2 Acquisition requirements. Acquisition documents should specify the following:
a.
Title, number, and date of this specification.
b.
Title, number, and date of the applicable specification sheet.
c.
d.
Applicable specification sheet PIN.
e.
Construction requirements, if other than specified (see 3.5).
f.
Gauge-type differential pressure indicator calibration requirements (see 3.5.3.1.3).
g.
Workmanship requirements, if other than specified (see 3.8).
h.
Test fluid and fluid temperature requirements, if other than specified (see 4.4).
i.
Packaging requirements (see 5.1).
j.
Provisioning requirements (see 6.4).
k.
Assembly drawing requirements (see 6.5).
l.
Indicators for logistic support requirements (see 6.6).
m. Fastener torque requirements (see applicable specification sheet).
6.3 Qualification. With respect to products requiring qualification, awards will be made only for products
which are, at the time of award of contract, qualified for inclusion in Qualified Products List QPL No. 24402
whether or not such products have actually been so listed by that date. The attention of the contractors is called to
these requirements, and manufacturers are urged to arrange to have the products that they propose to offer to the
Federal Government tested for qualification in order that they may be eligible to be awarded contracts or orders for
the products covered by this specification. Information pertaining to qualification of products may be obtained from
Commander, Naval Sea Systems Command, ATTN: SEA 05S, 1333 Isaac Hull Avenue, SE, Stop 5160,
Washington Navy Yard DC 20376-5160 or emailed to CommandStandards@navy.mil. An online listing of
products qualified to this specification may be found in the Qualified Products Database (QPD) at
6.3.1 Provisions governing qualification. Copies of SD-6, "Provisions Governing Qualification," are available
6.4 Provisioning. Provisioning Technical Documentation (PTD), spare parts, and repair parts should be
furnished as specified in the contract (see 6.2). When ordering spare parts or repair parts for the equipment covered
by this specification, the contract should state that such spare parts and repair parts should meet the same
requirements and quality assurance provisions as the parts used in the manufacture of the equipment. Packaging for
such parts should also be specified.
12
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business